GE AquaTrans AT600 - Density

AquaTrans™ AT600 User’s Manual 45
Chapter 4. Initial Setup and Programming
4.5.3 Density
To configure flow density, use the [] or [] arrow key to select Density
and press
[]. The following screen opens.
Use the [] or [] arrow keys to highlight the desired density type and
press [√].
Press [√] again and a screen similar to the following opens.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
User preference
Settings
Units Setting
Density
Password
Density
Density (Act)
Density (Std)
Density
Density (Act)
1000.000 Kg/m^3
Density (Act)
UNIT: Kg/m^3
1000.000
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[