GE AquaTrans AT600 - Page 65

AquaTrans™ AT600 User’s Manual 53
Chapter 4. Initial Setup and Programming
Setting the Pulse Value
Setting the Pulse Time
Use the [] or [] arrow keys to select
Pulse Value and press []. A screen
similar to the following opens.
The
Pulse Value is the amount of flow represented by one pulse in the
display. (e.g., 1 pulse = 10 m^3.) To change the existing setting, press
[]
and a screen similar to the following opens.
Note: The units shown are the units selected in the
Units Setting menu.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
Use the [] or [] arrow keys to select Pulse Time and press []. A screen
similar to the following opens.
The
Pulse Time (i.e., the pulse width) is displayed. To change the existing
setting, press
[] and a screen similar to the following opens.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
Pulse
Measurement
Pulse Value
Pulse Time
Test Pulse
Pulse Value
Pulse Value
10.0000 m^3
Pulse Value
UNIT: m^3
10.0000
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[
Pulse
Measurement
Pulse Value
Pulse Time
Test Pulse
Pulse Time
Pulse Time
5 ms
Pulse Time
UNIT: ms
5
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[