GE AquaTrans AT600 - Page 72

Chapter 4. Initial Setup and Programming
60 AquaTrans™ AT600 User’s Manual
Setting the Alarm Type
Setting the Alarm Value
Use the [] or [] arrow keys to select
Alarm Type and press []. A screen
similar to the following opens.
You can choose from three alarm types:
• Low: the alarm trips only if the measurement falls to or below the threshold
value
• High: the alarm trips if the measurement rises to or exceeds the threshold
value
• Fault: the alarm trips only for system errors, such as a power failure
To change the type of alarm, select the desired type and press
[] to return
to the
previous screen.
The
Alarm Value is the threshold that trips a Low or High alarm. To check
or change the alarm value, select
Alarm Value and press []. A screen
similar to the following opens.
Press
[] again, and a screen similar to the following opens.
Note: The units shown are the units selected in the
Units Setting menu.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
Alarm
Measurement
Alarm State
Alarm Type
Alarm Value
Alarm Type
Low
High
Fault
Alarm
Alarm State
Alarm Type
Alarm Value
Test Alarms
Alarm Value
Alarm Value
10.000 m/s
Alarm Value
UNIT: m/s
10.000
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[