Chapter 4. Initial Setup and Programming
62 AquaTrans™ AT600 User’s Manual
4.6.4.1 Modbus
Selecting the Baud Rate
To set up
Modbus, select Digital Comm on the Input/Output screen and press
[]. The following screen opens.
Press
[] again, and a screen similar to the following opens.
To set the baud rate, select
Baud Rate and press []. A screen similar to
the following opens.
The default baud rate is 115200. To change the default, select the desired
baud rate and press
[] to return to the previous screen.
Input/Output
Digital Output B
Digital Output C
Modbus/Service Port
Digital Comm
Baud Rate
Address
Bits/Parity
Stop Bits
To Next Page
Loading...
