September 2004
F-8 PanaView™ for IDM-Compatible Meters (916-086B)
Editing Meter Properties
(cont.)
The window appears similar to Figure F-9 below. To perform a
specific task, refer to the appropriate section on the following pages.
• Setting the Meter Clock (page F-9)
• Reading Transducer Signals (page F-10)
• Plotting Transducer Signals (page F-11)
• Saving Transducer Signals (page F-11)
• Clearing Totalizers (page F-11)
• Handling Site Files (page F-12)
Figure F-9: Properties Window for IDM-Based Meter
Note: For illustration purposes, the meter shown here is a one-
channel GN868 flowmeter. Specific parameters will vary with
your particular meter.
To Next Page
Loading...
