PanaView™ for IDM-Compatible Meters (916-086B) F-13
September 2004
Saving a New Site to the
Meter
To save a new site to the meter:
1. Select the radio button for New and click on the Save Site to Meter
button.
2. A window opens similar to Figure F-16 below. Enter the desired
name, and click [OK].
Figure F-16: Site Name Entry Window
3. The Site File Selection window (Figure F-15 on page F-12) opens.
Highlight a site with the desired settings, and click
[Open].
PanaView™ saves the site in the meter with the new name and the
desired settings.
Saving a Site to the PC To save a site to the PC:
1. Highlight the desired site in the left pane. (See Figure F-14 on
page F-12.)
2. Click Save Site to PC. A window opens similar to Figure F-13 on
page F-11.
3. Enter the desired site name and click
[Save]. PanaView™ saves the
site in the PanaView™ folder unless otherwise specified.
Note: If you have created a site on the meter after opening the Site
File Operations window, you must close and reopen the
window to click on the new site.
To Next Page
Loading...
