GE Baker Hughes PanaFlow LC XMT1000 - Page 52

Chapter 3. Programming
38 PanaFlow™ LC User’s Manual
2. In the Display/Totalizer, select [Composite] or [Channel x], then press [ENTER].
3. Then, select the totalizer measurement you would like to see on the Measurement View and press
[ENTER].
4. Press [] button on the keypad until the [or ] is highlighted to stop or start the totalizing
respectively.
5. Press [] button on the keypad until the [] is highlighted to reset/clear the totalized measurements.
Figure 52: Selecting Totalizer Measurements for Display
m^3
Rev Vol Total
0.000
0.000
m^3

3
Totalizer
Channel 1
Channel 2
Channel 3
Composite
Fwd Vol Total
9
2
9
2
9
or
Totalizer/Composite
Rev Vol Batch
Net Vol Batch
Batch Time
Fwd Vol Batch
Totalizer/Channel 1
Rev Vol Batch
Net Vol Batch
Batch Time
Fwd Vol Batch
Totalizer/Channel 1
Totalizer
Channel 2
Channel 3
Composite
9
2
9
or
Fwd Vol Total
m^3
Rev Vol Total
0.000
0.000
m^3

3
Totalizer/Composite
Fwd Mass Totals
Rev Mass Totals
Batch Totals Time
Net Mass Totals
Channel 1
Fwd Mass Batch
Rev Mass Batch
Batch Time
Net Mass Batch
(or)
Totalizer/Composite
Fwd Std Vol Batch
Rev Std Vol Batch
Net Mass Batch
Net Std Vol Batch
Totalizer/Channel 1
Fwd Std Vol Batch
Rev Std Vol Batch
Net Mass Batch
Net Std Vol Batch
๰
๰