GE Baker Hughes PanaFlow LC XMT1000 - 3.5.5 Option I;O Slot-2 (Optional)

PanaFlow™ LC User’s Manual 55
Chapter 3. Programming
3.5.5 Option I/O Slot-2 (Optional)
For extended I/O capability XMT1000 supports an Optional I/O that provides 2 additional Analog Outputs
(AO-AO), with up to 2 Analog Inputs (AI-AI) or 2 RTD (R-R) inputs. See Table 14 for all available options.
In this chapter AO-AO-AI-R 3 Wire,1000 Ohm option will be used as an example. Other options have similar
capabilities and menu map.
3.5.5a Option IO (Slot2): Setting up Analog Output
Use steps as in section “Log-in and Primary Pages” to navigate to the Input/Output settings page.
1. Highlight [Option I/O (Slot 2)] and press [ENTER].
2. Then highlight [AO-AO-AI-R-1000-3W] and press [ENTER]. Then highlight [Analog Output(S2:1)] or
[Analog Output(S2:2)] and press [ENTER].
3. If you do not wish to connect an Analog Output, you should turn Analog Output selection to OFF.
4. If you are connecting an Analog Output, choose 4-20mA option. Figure 63 below, shows the options
available.
5. Select the Measurement to be sent out on the 4-20mA output, followed by the [Base Value] and
[Full Value] selection. Refer to Table 3 to see measurement options available for Analog output.
6. Select [Error handling]. Refer to Section 3.5.5b to choose an option that suits your needs.
Table 14: Optional I/O available options
Board Option #
Input / Output Options
Available
1AO-AO-AI-AI
2 AO-AO-AI-R 3 Wire, 100 Ohm
3 AO-AO-R-R 3 Wire, 100 Ohm
4 AO-AO-AI-R 4 Wire, 100 Ohm
5 AO-AO-R-R 4 Wire, 100 Ohm
6 AO-AO-AI-R 3 Wire,1000 Ohm
7 AO-AO-R-R 3 Wire, 1000 Ohm
8 AO-AO-AI-R 4 Wire, 1000 Ohm
9 AO-AO-R-R 4 Wire, 1000 Ohm