GE Brivo OEC 715 - Page 366

Brivo OEC 715/785/865 Mobile C-Arm X-Ray Product Service Manual
6-32
Exception
ID
Error
Warning
Exception
Description
(In system Log)
Message
(Displayed in User Interface)
Diagnosis Reference
0307502
Warning
Get
measurement
information
from IE failed
Workstation communication
exception. Can’t get
measurement parameters
from the left monitor. Please
restart the system. If this issue
persists, please call for service.
1. Restart the system.
2. If not work, re-install
Workstation software.
0307503
Warning
Set
measurement
to IE failed
Workstation communication
exception. Can’t set
measurement data to the left
monitor. Please restart the
system. If this issue persists,
please call for service.
1. Restart the system.
2. If not work, re-install
Workstation software.
0307504
Warning
Set
measurement
unit to IE failed
Workstation communication
exception. Can’t set
measurement unit to the left
monitor. Please restart the
system. If this issue persists,
please call for service.
1. Restart the system.
2. If not work, re-install
Workstation software.
0307505
Warning
Set calibration
to IE failed
Workstation communication
exception. Can’t set
measurement calibration data
to the left monitor. Please
restart the system. If this issue
persists, please call for service.
1. Restart the system.
2. If not work, re-install
Workstation software.
0307506
Warning
Do calibration
exception
Calibration exception. Please
try again. If this issue persists,
please call for service.
1. Restart the system.
2. If not work, re-install
Workstation software.
0307507
Error
Measurement
module register
servant
exception
Workstation communication
exception. Please restart the
system. If this issue persists,
please call for service.
1. Restart the system.
2. If not work, re-install
Workstation software.
0307508
Error
Measurement
module
subscribe sync
event exception
Workstation communication
exception. Please restart the
system. If this issue persists,
please call for service.
1. Restart the system.
2. If not work, re-install
Workstation software.
0307509
Error
Measurement
module
unsubscribe
sync event
exception
Workstation communication
exception. Please restart the
system. If this issue persists,
please call for service.
1. Restart the system.
2. If not work, re-install
Workstation software.