System Overview
2-13
Power on/off button interface
The voltages applied to the power on/off button are listed as follows.
The button switch
on/off terminal
CMPTR_+12V interface
The +12VDC power from computer are listed as follows.
+12VDC Power from computer
Interlock interface
The interlock signals for cable &board are listed as follows.
PC power on/off switch interface
The switch on/off signal for PC are listed as follows.
PC ON/OFF Control
JTAG interface
System Interface Board interface
The signals to SIB are listed as follows.
system switch on/off signal
status of Mainframe Power
SEC_OVR_VLTGE_ERR
transformer secondary over
voltage signal
PJ8-4 digital 0/+12V (>6V=High)
SEC_UDR_VLTGE_ERR
transformer secondary
under voltage signal
PJ8-5 digital 0/+12V (>6V=High)
12V_ERR
+12V voltage from
computer fault signal
PJ8-6 digital 0/+12V (>6V=High)
RDY_ERR
WKS boot up ready fault
signal
PJ8-7 digital 0/+12V (>6V=High)