Wed adapterplug
Becauseof potential safety
hazardsunder certain conditions,
westrongly recommendagainst
useof an adapterplug, However,
if youstill elect to usean adapter,
where local codes permit, a
TIEfvIPORARYCONNECTIONmay
be madeto a properly grounded
two-prongwall outlet by useof a
ULlisted adapter (Fig. 2)available
at most local hardwarestores.
TEMPORARYMETHOD
PERMITTECIINCANADA)-
(ADAPTERPLUGSNOT
ALIGNLARGE
PRONGSISLOTS ~
- ““~~opER
T
?
●
# GROUNDAND
~ FIRMCONNECTION
Fig. 2
BEFOREUSE
The larger slot in the adapter must
bealigned with the largerslot in the
wall outlet to provideproperpolarity
in the connection of the power cord.
CAUTION:Attachingadapterground
terminal to wall outlet coverscrew
does not ground the appliance
unless cover screw is metal, and
not insulated, and wall outlet is
groundedthroughhousewiring.You
should havethe circuit checked by
a qualified electrician to makesure
the outlet is properly grounded.
When disconnecting the power
cordfrom the adapter, always
hold the adapter with one hand.
Hthis is not done, the adapter
ground terminal is very likelyto
break with repeated use.
Should the adapter ground
terminal break, IX) NOT USE the
appliance until a proper ground
has been established.
used extensionmm
Becauseof potentialsafety
hazardsunder certain conditions,
we’stmmglyrecommendagainst
the useof an extensioncord.
However,if youstill electto usean
extensioncord, it isabsolutely
“necessarythat it bea UL listed
3-wiregroundingtype appliance
extensioncord havinga grounding
type piug and outlet and that the
electrical rating of the cord be 15
amperes(minimum) and 120volts.
Such extensioncordsare
obtainablethrough your local
serviceorganization.
The freezershxddlalways
be pluggedintoitsown
indhfictualelectricaloutlet—
(115volt, 60 Hertz, single phaseAC.
Some models are also rated 100
volt, 50 Hertz. Checkthe model
and serial number plate.)This is
recommendedfor bestperformance
and to preventoverloading house
wiring circuits, which could cause
a possible fire hazardfrom
overheating wires.
FreezerWkMaticm
Location
Yourfreezershould be conveniently
located for day-to-dayuse in a dry,
well-ventilated room.
Formost efficient operation, it
should not be located where air
temperature around the freezer is
ever higher than 1lO°F.or colder
than 32*F.
Be sure to install your freezer on a
floor strong enough to support it
when it is fully loaded.
Also see Energy-Saving Tips
regarding location.
Allow 4 inches on top and 3 inches
at sides and hack for proper air
circulation.
AdjustableLegs
Turn left to raise—
Legsat the frontcornersof the
freezershould beset sothe freezer
isfirmly positionedon the floor,and
thefrontis raisedjust enough so
the doorcloseseasilywhen opened
about halfway.
Starting
1. Cleanthe inside of the freezer
with a mild solution of baking soda
and water (see page 12).
2. Connect cordto poweroutlet.
3. Turntemperature control to
No.4.This is the normal setting for
safe, long-term freezing. Forcolder
temperatures,turnto highernumbers.
4. Allowfreezerto operatefor at least
two hoursbeforeplacingfood inside.
TemperatureControl
Freezing temperature selection is
made by setting the control from
No. 1to No. 7 (coldest).
Normal, safe freezing level is
obtained by setting the control at
No.4.
OFF position permits turning the
freezer off without unplugging it.
To Next Page
Loading...
Need help?
General
