GE Cardiolab II Plus - Service Information; Service Requirements

1-14 Cardiolab® II Plus Amplifier Manual 2002938-002E
Introduction
CAUTION
CABLING — Route optical cables through conduit in the
ceiling or floor to avoid damage to the cables of cable
connectors.
CAUTION
TRANSDUCER — Remove air that is trapped in the
transducer or associated tubing by flushing the system
according to cath lab procedures.
Pressure channels should be calibrated to a known
pressure value if the pressure value is in question.
CAUTION
DEFIBRILLATOR PRECAUTIONS — ECG inputs are
protected against the use of a defibrillator in conjunction
with the use of the ECG cable.
The pressure inputs on the CardioLab II Plus Amplifier
are protected against the use of a defibrillator in
conjunction with the use of the recommended pressure
trandsucer and reusable cable.
CAUTION
POWER SUPPLY — The CardioLab II Plus Amplifier
may be safely powered by line voltages of 100-240 VAC
with frequencies of 50-60 Hz.
Service Information
Service Requirements
Follow the service requirements listed below:
 Refer equipment servicing to GE Medical Systems - Information
Technologies authorized service personnel only.
 Any unauthorized attempt to repair equipment under warranty voids
that warranty.