GE MEDICAL SYSTEMS CT9800 QUICK SYSTEM
Rev. 24 Direction 18000
4-10-11
R
INSTALL ‘CR’
* * * LOADING INSTALLATION WORK FILES
STATION TYPE (1=SCAN 2=INDEP): (The station you are presently at)
DOES YOUR SYSTEM HAVE AN HTD OPTION (YIN)
XENON OR HILIGHT DETECTOR (X/H):
HILIGHT DETECTOR ID NUMBER: XXXX (4 DIGITS)
HILIGHT DETECTOR ASSEMBLY NUMBER: (12 DIGITS, NO -, 46 NUMBER)
HOSPITAL NAME: (24 CHARACTERS MAX)
UNIQUE SYSTEM NUMBER: (SYSTEM ID NUMBER)
PREFERRED PHYSICIAN TITLE, DIAGNOSTIC IAN OR RADIOLOGIST (D/R):
LINE PRINTER? (Y/N):
OPTICAL DISK PRESENT (Y/N)
TAPE DENSITY (800/1600): [1600] (archive tape density)
MAG TAPE LENGTH (600/1600/2400): [2400] (large reel tape size)
IMAGE COMPRESSION TO TAPE (Y/N): [Y] (Image compression stores more images per
tape)
STARTING ARCHIVE TAPE ID: (1-32699. Check patient log book for last
number.)
DISK TYPE (1 = ARGUS, 2 = ACE : 1) (If the system is configured with a Zebra disk
drive or HTD option, this question will not appear.
If the system has an Argus. enter 1; If the
system has an Ace, enter 2)
2 DISK DRIVE SYSTEM (Y/N): (If the system is configured with ACE disk
drive(s) this question will not appear)
BONE MINERAL DENSITOMITRY AT THIS SITE?(Y/N):
DATALINK PRESENT (Y/N): (If N, no further DataLink questions asked)
NUMBER OF STATIONS: n (1-26) (Each DataLink box contains a dip switch
which identifies station or node number.
Numbering is sequential from 1 to 26. “O” is not
used and no numbers are skipped. Backup packs
must have same Station ID).
STATION ID (1-n): (ID’1 of station you are loading software on.)
IMAGE TAPE STATION ID (1-n):(The ID of station where image storage is usually
performed. Refer to DataLink Section of the
Operator Manual for more details, if desired).
To Next Page
Loading...
