GE CT-9800 - Page 136

GE MEDICAL SYSTEMS CT 9800 QUICK SYSTEM
Rev. 24 Direction 18000
4-10-14
The system then lists all of the above MCOORD assignments, e.g.
CX CTEX$xx
etc.
==================================================================================
........This version of the system software is configuration...................
............Rev CLFC_WD.............VT# 13............21-MAY-90................
......... Here at the ‘R’ level the following options exist
UP -------------- Prerequisite for ‘M’ which prepares the system
M --------------- Is the actual CT 9800 Scan-Display-Reconstruction program
TAPES ----------- 8800-to-9800 archive-tape conversion program
EMIARCHIVE 8800 program. Use 8800 ARCHIVE and REMOVE also (see note below)
DOWN ------------ Allows orderly shutdown of the operating environment
CLEANUP --------- Allows cleanup of DATABASE if problems. -use sparingly-
SNAPS ----------- Snapshot error logs and copy to magnetic tape - MTO
............. Also special programs for Calibration
QCAL ----------- This is a special calibration required for new tubes
REGEN ----------- This program establishes the CT values of phantoms
and allows modification of selected INSTALL parameters
............. Also special programs for Characterization and Status
MG (CTDS) - This test program ‘Characterizes’ the XRAY Generator
CH (CTDS) - This program ‘Characterizes’ the Table mechanics
ZR (CTDS) - PPI status display program
Pick your option terminated with ‘RETURN’ or ‘ENTER’
YOU MIGHT LIKE TO REVIEW THE RELEASE NOTICE - ‘9800.RN’ (Enter: TYPE 9800.RN ‘CR’)
ENTER ‘DATE’ AND ‘TIME’ AND THEN RUN ‘UP’
MASTER DEVICE RELEASE
RUNNING EXTENDED TESTS - PASSED (MV7800)
Loading MV/7800 microcode revision XX (MV7800)
MV/7800 microcode loaded (MV7800)
CT Operating SYSTEM - VER 7.3M
STAND BY ....
DATE mm/dd/yy* (Date automatically entered for MV7800. Type in date for S140, i.e., M/D/Y ‘CR’)
TIME 14:30:19 (Time automatically entered for MV7800. Type in military time for S140, i.e., H:M:S ‘CR’)
R
UP ‘CR’
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
! CT 9800 System preparation in progress...
! Please stand by...
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
R (AP software is loaded; you are back at DA0 or DZ0; and ready for scanning (at M
level).
* For Year greater than 1999, type 4 digits, or 1XX (e.g. 2005 = 105).