Datex-Ohmeda S/5 Anesthesia and Critical Care Monitors
60
Document no. M1137266-02
Table 11 BIS Engine and DSC error messages
Message Errors of type 1
DSC buffer overrun
Out of dynamic memory
Execution time exceeded in main
Error in algorithm processing
Invalid state in UART receive state machine UART related errors
UART initalization error
Transmit queue full
Illegal number of data bytes for packet to
be transmitted to the Host
Illegal number of channels for EEG data Misc. errors
Illegal EEG data type
Illegal EEG data rate
Illegal EEG filter coefficients
No updates from Host Communication related
errors
Bad CRC - TI_SELFTEST_CODE EEPROM CRC checks
Bad CRC - TI_RUN_CODE
Bad CRC - FPGA_CONFIG
Bad CRC - REV_INFO
Illegal serial number Serial number check
DSC failed to power up DSC related errors
Serious DSC overcurrent error
DSC receiver data overrun
DSC failed repeatedly in responding to
commands
DSC update failed
Serious DSC power regulation fault
General DSC failure
Sensor Negative Ground Fault Smart sensor errors
Serious Sensor Positive Ground Fault
Serious Sensor Overcurrent Fault
To Next Page
Loading...
