GE Datex-Ohmeda S/5 - Central Processing Unit, F-CPU

Datex-Ohmeda S/5 Anesthesia and Critical Care Monitors
30
Document no. M1125636-05
3.3.4 Central Processing Unit, F-CPU
1. Press the service reset button with an appropriate
tool for at least five seconds before removing any PC
board or the Power supply unit from the rear of the
Central Processing Unit, F-CPU.
2. Remove the following boards from the back of the
F-CPU.
- B-UPI4NET. Pull it slightly out and disconnect the
cable (red connector) from the board.
- B-DISPX, optional
-B-CPU6
- F-CPU power board
-Plates covering possible empty slots
- Remove the six screws from the bottom of the
F-CPU.
- You can now detach the F-CPU upper cover.