GE Datex-Ohmeda S/5 - Connections; Device Interfacing Solution Components

Datex-Ohmeda S/5 Anesthesia and Critical Care Monitors
52
Document no. M1137263-04
For specific information on parameters transferred from the interfaced device to the
Datex-Ohmeda monitor and the applicable software versions of the device refer to the
Installation guide accompanying each DIS module.
4.2.1 Device Interfacing Solution components
The Device Interfacing Solution consists of:
− a device specific interfacing module
− a device specific cable
− a bus cable
− a connector for another bus cable
− label specifying the external device
4.2.2 Connections
Connect the device specific cable to the external device and the bus cable to the S/5
Anesthesia / Critical Care Monitor’s UPI4 or UPI4NET board or to the monitor's DIS connector or
to another interfacing module.
N-DISRGM
RGM Monitor
5
N-DISTONO
Tonocap
5
N-DISWHITE
Capnomac, Capnomac II
5
Multicap, Normocap, CD2-O2
5
Capnomac Ultima
5
Normocap CD-200
5
Oscar Oxy, Cardiocap 1GS, Cardiocap 2GS
5
Satlite, Satlite Trans, Satlite Plus
5
1 Trademark of Hospira Inc. (previously trademark of Abbott Laboratories)
2 Trademark of Aspect Medical Systems
3 Trademark of Edwards Lifesciences Corporation
4 Trademark of Pulsion Medical Systems
5 Trademark of GE Healthcare Finland Oy
Device Blood gas analyzers
N-DISOPT
AVL Opti CCA
1
1 Trademark of Diamond Diagnostics Inc
Device Heart-lung machines
N-DISHL20
Jostra HL-20
2
2 Trademark of MAQUET GmbH & Co. KG part of the Getinge Group