Problem
Possible Causes
What to Do
O_ra_ring
No fabric softener was used
Synthetics, permanent press
and blends can cause static
• Try a fabric softener.
• Adjust controls for less drying.
• Try a fabric softener.
• Try a fabric softener.
Improper sorting
• Separate heavy items from lightweight items
(generally, a well-sorted washer load is a
well-sorted d_er h)ad).
Large loads of heavy fabrics • Large, heavy fabrics contain more moisture
(like beach towels) and take longer to dry. Separate large, heavy
fabrics into smaller loads to speed drying time.
Controls improperly set • Match control settings to the load you
are drying.
Lint filter is full • Clean lint filter betore every load.
Improper or obstructed
ducting
Blown fuses or tripped
circuit breakers
Overloading/
combining loads
Underloading
• Check installation instructions for proper
ducting/venting.
• Make sure ducting is clean, free of kinks
and unobstructed.
• Check to see if outside wall damper
operates easily.
• See the Venting the Dryer section.
• Replace fuses or re set circuit breakers. Since
most dryers use 2 fuses/breakers, make sure
both are operating.
• Do not put mort.- than one washer load in
the dryer at a time.
• If you are drying only one or two items,
add a few items 1:oensure proper rumbling.
17
To Next Page
