Aboutthe dryercontrolpanel
O Dry Temp
You can chanoe_ the temperature ot your dry cycle.
ANTI-BACTERIAL
(on some models)
Thisoptionmayonlybeusedwith COTTONSor MIXED LOADcycles.Thisoptionreducescertain
typesof bacteriaby 99.9%,including:Staphy/ococcusaureus,PseuflomonasaeruginosaandK/ebsie//a
pneumoniae*.Theanti-bacterialprocessoccurswhenhigh heatis usedduringa portionofthis
dryingcycle.
NOTE:Donot usethis cycleondelicatefabrics.
TheAnti-BacterialCycleis Certifiedby NSFInternational(formerlyNationalSanitationFoundation)
to NSFProtocolP154SanitizationPerformanceof ResidentialClothesDryers.
NSF Protocol P 154 ]
S midzatio_l Perfbrmailce of
Residential (_]othes Dryers
HIGH Forregularto heavycottons.
MEDIUM Forsynthetics,blendsanditems labeledpermanentpress.
LOW Fordelicates,syntheticsanditems labeledTumb/eDryLow.
EXTRALOW Forlingerieandspecial-carefabrics.
NO HEAT Canonlybeusedwith TIMED DRY.
(onsomemodels)
O START
Press to start a (h'_ cycle. If the (h'_er is Hmning press it once and it will pause the dr_er.
Press it again to restart the dry c_cle.
My Cycle (on some models)
Set up your fh\'orite combination of settings and save them here for one touch recall.
These custom settings can be set while a cycle is in progress.
Tostore a MY CYCLEcombination of settings:
I. Select your drying cycle.
2. Change DRY TEMP _nd SENSOR DRYLEVEL settings to fit your needs.
3. Select any drying OPTIONSw)u want.
4. Press and hold the _ pad for three seconds to store your selection. A beep will sound
and the pad will light up.
Torecall your stored MY CYCLEcombination:
Press the MYCYCLEbutton belore drying a load.
Tochange your stored MY CYCLEcombination:
Follow steps 1-4 in "To store a MY CYCLEcombination of settings"
@
"CLEAN LINT FILTER"(message)
(This message represents only a reminder.)
After the POWER button is pressed, the "CLEAN LINT FILTER"message could appear if the prexious
c_cle was not finished.
This messaoe,,_ will disappear after the STARTbutton is pressed.
Exert thouoh you have already cleaned the filter (befi_re or after the POWER button has been
pressed), the "CLEAN LINT RLTER'message will still be displa)ed until the SYARYbutton is actixated.
8
To Next Page
Loading...
