K415 Issue No. 1 10
TASK key
The TASK key is used to set-up the instrument for a number of specific types of test.
There are two modes BASIC and ADVANCED and nine other specific types of test that
automatically configure the instrument on selection from the TASK menu. The tasks
available under the TASK menu are held on three pages shown below. To select a task
from the menu, press the TASK key, position the cursor over the required task and press
the ENTER key as shown below. Use the right/left cursor keys to switch between pages.
Using Task Functions
Specific tasks are selected as shown above. The following diagrams show how to
connect the unit under test (UUT) for each task selectable under the TASK menu.
Input and output units, where applicable, can be selected by pressing either the INPUT or
OUTPUT keys as shown below. The output key also provides the facility of turning the 24V
output supply ON and OFF. When not in use, the 24V supply output should be turned OFF
to conserve battery power.
Set Units
Note: If the four units displayed are not the units required, press SETUP, select SETTINGS
and refer to page 38.
Set 24 Volts
STANDARD
UTILISATEUR
FONCTIONS
P - PRESSOS
CONFIG.
SOUPAPE
TESTFUITE
TRANSM
FONCTIONS
P - VALEUR
P-I
I-P
P-P
P-V
Courant (Page 2) (Page 3)
FONCTIONS
OUTPUT
SELECTIONNER
FONCTION
24 VOLT
OFF
UNITES
ON
inHg
hPa
Pa
bar
SELECTIONNER
FONCTION
CHOIX UNITES
DE PRESSION
SELECTIONNER
UNITES
OUTPUT
SELECTIONNER
MARCHE/ARRET
SELECTIONNER
FONCTION
24 VOLT
OFF
UNITES
24 VOLT
ON
UNITES
ON
SELECTIONNER
FONCTION
SELECTIONNER
FONCTION
Task Selection
To Next Page
Loading...
