GE Druck DPI 615 - Min;Max Process Function; Filter Process Function

23 K415 Issue No. 1
Max/Min Process Function
To set-up an input display to show max/min and present input reading, enable
MAX/MIN from the process menu and press F1 (SETTINGS) to provide RESET
function. The display now shows the max/min values as follows:
Reset Max/Min display at any time by pressing the
F1 key.
To quit max/min, press INPUT, select MAX/MIN
from process menu and switch the function off.
Filter Process Function
To apply the low pass filter to a selected input, enable FILTER from the process
menu and press F1 (SETTINGS) to provide access to the filter parameters. Two
settings are required, Time to Settle and Band.
To examine the current filter settings and exit without change, press the EXIT key.
The set-up procedure is as follows:
FCT. : CONFIG
MODE ENREG. RAPIDE
24V OFF
ACTUEL
RESET
MAX/MIN
PERIODE
HEURE =
2 Seconds
BANDE = AMPLITUDE MAX
QUI DOIT FILTREE VARIATIONS
SUPERIEURESA LA BANDE DU
FILTRE
BANDE = 1.5 % FS
PERIODE
HEURE = 2 Seconds
BANDE =
1.5 %FS
CONFIG.FILTRE CONFIG.FILTRE
SELECTIONNER
VALEUR
SELECTIONNER
VALEUR
BANDE = AMPLITUDE MAX
QUI DOIT FILTREE VARIATIONS
SUPERIEURESA LA BANDE DU
FILTRE
CHANGER
VALEUR
CHANGER
VALEUR
Advanced Task Process Functions