K415 Issue No. 1 24
Flow Function
To apply the flow function to a selected input, enable FLOW from the process
menu and press ENTER. The square root symbol is displayed beside the input
value to indicate that the FLOW function is active:
To cancel FLOW, press INPUT and turn function
OFF at the process menu.
%Span
To convert a selected input display from a numerical value to a percentage of
full-scale reading, enable SPAN from the process menu and press F1 (SETTINGS)
to provide access to the span definition parameters. Two span definitions are
required, Zero and Full Scale.
To leave span at current setting, press EXIT.
To define zero and full-scale settings, proceed as follows:
To cancel %SPAN, press INPUT and turn function OFF at the process menu.
bar
V
FCT. : CONFIG. 24V OFF
MODE ENREG. RAPIDE
SELECTIONNER
VALEUR
SELECTIONNER
VALEUR
DEFINE ECH.
VALEUR AFFICHEE
V
50.000 V
0% =
100% =
ENTER UNE VALEUR OU F2
POUR SELECTIONNERVALEUR
ACTUELLE OU EXIT POUR
QUITTER SANS MODIFICATIONS
DEFINE ECH.
VALEUR AFFICHEE
V
V
0.0000% =
100% =
_
_
ENTER UNE VALEUR OU F2
POUR SELECTIONNERVALEUR
ACTUELLE OU EXIT POUR
QUITTER SANS MODIFICATIONS
CHANGER
VALEUR
CHANGER
VALEUR
LECTURE
ACTUELLE
LECTURE
ACTUELLE
Advanced Task Process Functions
To Next Page
Loading...
