GE Druck DPI 615 - Ma Ramp

27 K415 Issue No. 1
mA Ramp
Press the OUTPUT key and select mA RAMP as shown previously in mA Step.
• Define ramp required by entering START and END current values as shown below:
• For current sourcing applications, turn on the 24V supply as shown on page 28. For
current sinking applications, connect an external supply as shown on page 25 and
leave the 24V supply switched OFF.
•Press START (F1) to run the program. A status display CHECK LOOP indicates a fault
in the external loop i.e. supply fault or open circuit.
Note: The ramp cycle (min to max or max to min), is approximately 60 seconds.
•Press STOP (F1) when running to stop at any point. Press CONTINUE (F1) to resume
from point of pause or RESET (F2) to return to start point.
ENTRER VALEUR
ENTRER VALEUR
bar
DEBUT
DEBUT
SORTIE
FIN
mA
ARRET
FCT. : CONFIG.
MODE ENREG. RAPIDE
bar
DEBUT
DEBUT
SORTIE
FIN
mA
ARRET
FCT. : CONFIG.
MODE ENREG. RAPIDE
24V OFF 24V OFF
ENTRER VALEUR
ENTRER VALEUR
bar
DEBUT
DEBUT
SORTIE
FIN
mA
ARRET
FCT. : CONFIG.
MODE ENREG. RAPIDE
bar
ARRET
DEBUT
SORTIE
FIN
mA
FCT. : CONFIG.
MODE ENREG. RAPIDE
EN COURS
24V OFF
24V OFF
ENTRER VALEUR
ENTRER VALEUR
bar
ARRET
DEBUT
SORTIE
FIN
mA
ARRET
FCT. : CONFIG.
MODE ENREG. RAPIDE
bar
CONTINUE RESET
DEBUT
SORTIE
FIN
mA
FCT. : CONFIG.
MODE ENREG. RAPIDE
PAUSED
24V OFF 24V OFF
Advanced Task Select Output