K415 Issue No. 1 28
mA Value
Press the OUTPUT key and select mA VALUE from the output menu. The procedure is
shown below:
• For current sourcing applications, turn on the 24V supply as shown below. For
current sinking applications, connect an external supply as shown on page 25 and
leave the 24V supply switched OFF.
•Use up and down cursor keys to adjust output current level. While the loop is
made, a status display indicates OK. A status display CHECK LOOP indicates a fault
in the external loop i.e. supply fault or open circuit.
24 Volt
Press the OUTPUT key and select 24 VOLT from the Output menu. The procedure is
shown below:
Note: The 24V selection is located on the second page of output functions.
Note: To conserve battery power, keep the 24V supply switched off when not in use (even
if the output is unloaded).
CHOISIR SORTIE
REGLER NIVEAU
SELECT SORTIE
PRESSION INT
PRESSION EXT
PAS mA
RAMPE mA
VALEUR mA
bar
SORTIE
NOUV VAL
mA
OK
FCT. : CONFIG.
MODE ENREG. RAPIDE
24V OFF
OUTPUT
VALIDER
SORTIE
SELECTIONNER
SORTIE
SELECT SORTIE
24 VOLT
OFF
PAS DE SORTIE
SELECT SORTIE
24 VOLT
ON
PAS DE SORTIE
Advanced Task Select Output
To Next Page
Loading...
