35 K415 Issue No. 1
Running Procedure Files (DPI 615 instruments only)
To run a procedure, make sure the instrument is set to the Store mode, Data Log (see
page 37), and proceed as follows:
After selecting F1, proceed by entering the User ID and Serial Number and then select F1
(Continue) and follow the on-screen procedural instructions:
When the test procedure for a given UUT has been completed, the result of running the
first test is stored as an AS FOUND file. This file cannot be overwritten. Any subsequent
tests on the device are stored as an AS LEFT file that is overwritten each time the
procedure on this device is run.
When recalling the results of a procedure, the choice of AS FOUND or AS LEFT is provided
(refer to page 36).
G3459
FEEDPRESS11
TEST1
TEST5
TEST2
ERASE
RECALL
MEMORY USED
FILE 1 of 9
DATE: 04/11/99 TIME 10:18
RUN
PROCEDURE
REVIEW
LOGGED FILE
DEVICE UNDER TEST
I/P LOW:
I/P HIGH
O/P LOW:
O/P HIGH
0 BAR
20 BAR
0 VOLTS
10 VOLTS
SELECT FILE
FEEDPRESS11
MAX PRESS:
POINTS:
MAX. ERROR:
22
5 UP/DOWN
0.1% SPAN
bar
V
FEEDPRESS11
LOG
NOW
..........
%span PASS
GO TO 0.000 bar
0.04
bar
V
FEEDPRESS11
24V OFF
LOG
NOW
..........
%span PASS
GO TO 5.000 bar
0.04
bar
V
FEEDPRESS11
..........
%span PASS
GO TO 0.000 bar
DATA POINT LOGGED
SETUP & LOG POINT 1 SETUP & LOG POINT 2 etc.POINT 1 STORED
24V OFF24V OFF
Memory Operations Data Log
To Next Page
Loading...
