v K415 Issue No. 1
Introduction
General
Description of Procedures 1
Summary of Functions
Using the Guide 2
OPERATOR CONTROLS 3
DISPLAY 3
HARD KEY FUNCTIONS 4
SOFT KEYS 5
CURSOR KEYS 5
ELECTRICAL CONNECTIONS 6
Getting Started
Fitting Batteries 7
Switching On 7
Change Pressure Units 8
Voltage and Current Measurement 8
Typical Calibration Set-up (Pressure to Voltage) 9
Zero Display Reading 9
Task Selection
Task Key 10
Using Task Functions 10
Set Units 10
Set 24 Volts 10
Cal Mode (DPI 615 versions only) 11
Basic Mode (Task BASIC) 11
Taking Measurements
Pressure Transmitter (P-I) Task 12
Voltage Output Pressure Transmitter (P-V) Task 12
Pressure Converter (P-P) Task 13
Current to Pressure Converter (I-P) Task 14
Pressure Switch Test (P-Switch) Task 14
Pressure Switch Testing with Contact Resistance Measurement 15
Pressure to Display (P-Display) Task 16
Leak Test (Leak Test) Task 17
Transmitter Simulator (TX SIM) Task 18
Relief Valve Test (REL VALVE) Task 19
To Next Page
Loading...
