Quick Start Guide Druck DPI 620 Genii
3 May 2013 K0542 Issue 2 1-3
4 Install the Battery
1. Remove the five Pozidriv screws (A) (Ref: Fig 1, Rear View).
2. Remove the battery cover.
3. Check the connections on the battery line up with the connections
in the battery compartment.
4. Place the battery in the battery compartment.
5. Replace the battery cover.
6. Secure the cover with the five Pozidriv screws.
Fig 1 Rear View
5 Charge the Battery
1. Connect the DC power supply/battery charger unit in to the +5V
DC
connection on the side of the unit (Ref: Fig 2 Side View).
2. The battery can also be charged using the USB connections (Ref:
Fig 2 Side View).
3. The unit can be On or Off when charging. Charging times maybe
longer if charging when the unit is On.
5.1 Battery Charging
Charging Connection Charge Time
DC Power Supply 6.5 Hours
External Battery Charger 6.5 Hours
Mini USB Connection 13 Hours.
To Next Page
Loading...
