Chapter 3: Programming
160 EST iO64 and iO500 Technical Reference Manual
Zone 01>
Label goes here
Label continued
<Save <Back
To label your zones:
1. Next to "Zone," select the zone (number) that you want to label.
2. Enter a text label for the zone (up to 40 characters and two
lines). The default label is "Zone XX."
3. Press Enter to save the label and go to the next zone (number).
Note: Pressing the Enter button saves the current label and then
goes to the next zone number so that you can quickly go to
each zone and label it.
4. Enter a text label for the zone (up to 40 characters and two
lines).
5. Repeat steps 3 and 4 until all zones are labeled.
6. When you are finished labeling, make sure the cursor is on the
zone number, and press the Cancel button to exit and go to the
next incremental programming option.
To Next Page
Loading...
Need help?
General
