ge.com
_JStart/Reset
D
Closeand latchthe dishwasherdoor and selectthe cycle and desiredenhancements.Touchthe
START/RESETpadto begin the cycle.Thewater fill begins immediately,and approximately 60 seconds later
the wash action begins.
Whenthe dishwasher door isfully closed and latched,the control panel lightswill display the last settings
you selected.Ifyou don't want to change any of thesettings, siimplytouch the START/RESETpad to begin
the cycle.
Ifthe door isclosed,the indicator lightswillturn off if the START/RESETpad is not selectedwithin 5 minutes.
Toactivate the display,open and closethe door or pressany pad.
DELAY HOURS
RESET
Youcan delay thestart of a wash cycle for up to 6 hours.Pressthe DELAYSTART
pad to choosethe number of hours youwant to delay the start of the cycle;then
pressSTART/RESET.
Themachine will count down and start automatically at the correct time.
NOTE:Tocancelthe DELAYSTARTselection beforethe cyclebegins,repeatedly pressthe
DELAYSTARTpad untilthe display is blank.
Tochange a cycle after washing starts:
Touchthe START/RESETpad to cancel the cycle.TheSTART/RESETlight willflash while
the water ispumped out, if needed.Thistakes approximately 2 minutes.
Time Remaining Display (onsome models)
During operation, the display shows the minutes remaining until the cycle iscomplete. The display
may adjust the remaining time while the SENSINGlight is on.The time displayed at the start of each
cycle may change from the factory setting asthe unit customizes itself to home use.Duringa delay
start, the display will show hours of time remaining untilthe cycle starts.
Clean
TheCLEANlight is illuminated when the selected cycle and enhancements are complete. The light will
stay ONuntil a pad is pressedor the door is opened and then closed.
To Next Page
Loading...
Need help?
General
