GEAppliances.com
Select Options
The light above the selected pad will be ON to indicate which Option has been selected.
HEATEDDRY Turnsthe heateron for fast drying.Thiswill extend the total cycle time by approximately 38 minutes fora
Light On NORMALWASHcycle.
NOTE:Cannot beselectedwith RINSEONLYcycle.
HEATEDDRY Shutsoff the drying heat option. Disheswill air dry naturally to saveenergy.
Light Off
HOTWASH When selected,the cycle will run a little longer with heating elements on to improve both wash and dry
performance. Adds approximately !5 minutes to the cycle.
NOTE:Cannot be selectedwith RINSEONLYcycle.
HOTSTART Foruse with heavilysoiled and/or dried-on,baked-on soils.ThisOption ivlUSTbe selected PRIORto starting the
cycle.Thisoption adds approximately 22 minutes to the cycle and two additional rinsesto the cycle.
NOTE:Cannot be selectedwith RINSEONLYcycle.
LOCK You can lock the controls to prevent any selections from being made. Or you can lock the controls
after you have started a cycle.
Children cannot accidentally start dishwasher by touching pads with this Option selected.
To unlock the dishwasher controls, press and hold the HEATEDDRY pad for 3 seconds. The light
above the lock pad will turn off.
To lock the dishwasher controls, press and hold the HEATED DRYpad for 3 seconds. The light above
the lock pad will turn on.
DELAYHOURS
You can delay the start of a wash cycle for up to 6 hours. Press the DELAYHOURSpad to choose the
number of hours you want to delay the start of the cycle; then press START/RESET.
The machine will count down and start automatically at the correct time.
NOTE:To cancel the delay start selection before the cycle begins, repeatedly press the DELAYHOURS
pad until the display is blank.
Start Dishwasher
START The door must be closed to select the desired Options. Press the START/RESETpad to begin the cycle
within 5 minutes of the door closure or begin the DELAYHOURS countdown. The illuminated lights
will also turn off if more than 30 seconds passes between pressing a pad. To activate the display, open
and close the door or press any pad.
Interrupt To interrupt or pause a dish cycle, slowly open the door. Opening the door will cause the wash cycle
or Pause to pause. The dishwasher will beep every minute to remind you to close the door. To restart or
resume the cycle, press START,and close the door.
Cancel
To cancel o wash cycle, touch the START/RESETpad. The START/RESETlight will flash while the water
is pumped out, if needed. This takes approximately 2 minutes.
Indicator Light
CLEAN TheCLEANlight isilluminated when the selected cycle and enhancements are complete. The light will stay
ON until a pad ispressedor the door isopened and then closed.
Display
Time Remaining During operation, the display shows 1H if the time remaining is over an hour and will show the
minutes remaining if the time remaining is below an hour. During a delay start, the display will
show hours of time remaining until the cycle starts.
To Next Page
Loading...
