GE GLDA696FSS - Dimensions And Installation Information Manual

Dimensions and Installation Information (in inches)
For answers to your Monogram,
®
Cafe
™
Series,
Profile
™
Series or GE
®
appliance questions, visit
our website at geappliances.com or call GE
Answer Center
®
service, 800.626.2000.
Specification Created 7/13
350241
• The rough cabinet opening must be at least 24" deep,
24" wide and approximately 32-1/2" to 34-3/4" high f
floor to underside of the countertop.
4"
6"
5"
5"
4"
Figure A
Floor MUST be Even
W ith Room Floor
Cabinet
s
Square
and
Plumb
This Wall Area
must be Free
of Pipes or
wires
24"
Min.
24"
Min.
32-1/2" to 34-3/4"
Underside of
Countertop
to Floor
Plum bing and Electric Service
Must Enter Inside This Area
Electrical Rating
Voltage AC............................................................120
Hertz......................................................................... 60
Total connected load amperage................. 6.7
Calrod
®
heater watts max............................650
For use on adequately wired 120-volt,
15-amp circuit having 2-wire service
with a separate ground wire. This appliance
must be grounded for safe operation.
Note: The rough cabinet opening must be at
least 24" deep, 24" wide and approximately
34-1/2" high from floor to underside of
the countertop. Dishwasher must not be
installed more than 10 feet from sink for
proper drainage. All plumbing and
electrical work must be in accordance
with local codes. The power cord and
connections must comply with the National
Electrical Code Section 422 and/or local
codes and ordinances. The cord must be no
longer than 6 ft. from the junction box to
the receptacle.
Installation Information: Before installing,
consult installation instructions packed with
product for current dimensional data.
GLDA690FWW/GLDA690FBB/GLDA696FSS
GE
®
Stainless Steel Interior Dishwasher with Front Controls
Listed by
Underwriters
Laboratories