HOW TO OPERATE YOUR DISHWASHER
I
I
STEP 1. Load your dishwasher with dishes, silverware,
pots, pans, bowls, etc., according to the Loading section.
STEP 2. Add detergent to the detergent dispenser.
Make sure the Cycle Indicator Dial is
at
OFF position
before adding detergent. (See Detergent Guide.)
Use rinse aid agent to help prevent spotting.
Occasionally check to insure that rinse agent
container is at least half full. (See How to Use
a Rinse Agent section. )
STEP 3. Select drying option.
HEATED DRYING. Turns the
drying heater on for fast drying.
m
ENERGY SAVER (no-heat boost).
Turns the drying heater off to save
energy. Dishes will dry naturally
Iml
over a longer period such as overnight.
If you need your dishes sooner, open the dishwasher
door after the cycle is complete to reduce the natural
drying time.
Note: The ENERGY SAVER option will also cancel the
WASH HEAT BOOST. To obtain WASH HEAT BOOST
without HEATED DRY, select only the WASH HEAT
BOOST option. (See Energy-Saving Tips
section).
STEP 4. WASH HEAT BOOST Option
WASH HEAT BOOST. This cycle
will be extended for 21 minutes while
the dishwasher automatically heats the
water for good washing and drying. The
entering water
mu~~~ at least
120°F.
n
WASH HEAT
BOOST
❑
.
When this option
is%e]ected
entering water must
be at least
140°F.
To test water, see How to Test Water
Temperature section.
STEP 5. Select the wash cycle and start the dishwasher.
(See Cycle Selection
Hints:)
● For POTSCRUBBER, NORMAL
r
WASH and LIGHT WASH cycles:
SCRUBBER WASH
a. Push selected
cycle
button.
I
I
K[ll
b. Latch the door.
c.
Slowly
turn Cycle Indicator
Dial to ON position to start
the cycle. You will hear the motor start. There is a
time delay between start-up and water fill so you
will
not hear any wash action right away.
To obtain the benefits of a complete cycle, be careful
that you do not turn the dial any further than
necessary to start the dishwasher. If your dishwasher
drains into a food waste disposer, operate the disposer
until it is empty before starting the dishwasher.
● For RINSE & HOLD cycle:
a. Be sure door is unlatched.
I
IGHT
RINSE
ASH & HOLO
b. Select ENERGY SAVER
1
~
drying option.
c. Slowly turn Cycle Indicator Dial
to the ON position.
d. Latch the door to start the cycle
Cycle Selection Hints
[t
is important to
follow
the Loading instructions.
● POTSCRUBBER—For items such as pots, pans and
casseroles with dried-on or baked-on soils. Everyday
dishes may be included.
● NORMAL WASH—For loads of everyday dishes,
glasses and cookware with medium soils. Designed
to yield high performance on normal soils.
● LIGHT WASH—For dishes that have been
/)re-
rin.~ed
before loading. Also, for washing
very
Iightl)
soiled dishes with soils that have not dried on.
● RINSE & HOLD—For rinsing partial loads which
will be washed later.
Do
not
u,~e
detergerlt.
Delay
Start
i.s
not
recommended,fi)r
thi.~
cycle.
4
To Next Page
Loading...
Need help?
General
