Installation Instructions
REVERSINGTHE DOOR SWING (CONT.)
[_] REMOVE THE FRESHFOOD DOOR
3.1 Tape the door shut with masking tape.
3.2 Using a 5/16" hex-head socket screwdriver and a
5/16" open-end wrench, remove the two screws
holding the center hinge to the cabinet. Lift the
center hinge to free its pin from the socket in the
top of the door, and set hinge and screws aside.
Be careful not to lose the center hinge spacer and
washer.
----____=__j_
3.3 Remove the tape and tilt the door away from the
cabinet. Lift the door from the pin in the bottom
hinge bracket. (If the plastic washer sticks to the door
bottom, put it back on the hinge.)
3.4 Set the door outside-up on a non-scratching surface.
[_] REMOVE THE FRESH FOOD DOOR (CONT.)
3.5 Transfer the two screws from the opposite side of the
cabinet to the screw holes vacated by the center hinge
removal.
3.6 Transfer the washer (if your model has one) to the
opposite side.
J
3.7 Take one of the screws removed in step 2 and start
it in the outermost screw hole on the opposite side.
Do not drive it oll the woy down-leove enough spoce
under the screw head for thickness of the bracket.
J
T-----
[_ REVERSINGTHE HARDWARE
4.1 Move the bottom hinge bracket and plastic washer from
the right side to the left side.
/I I Plastic
[ _,_./Washer
Switch the hinge pin to the ¢-!!@-- [ _J
opposite side of the bracket. [_'-_t_
Hinge-/_" ...... _D
Bracket
12
To Next Page
Loading...
