GE GTH21SBXASS - Icemaker Installation - Components and Cover

Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS (CONT.)
[_INSTALL THE ICEMAKER FILL CUP
Install the icema_ker fill cup (skle-mom_ted) into the
icemaker as shovcn,
[_ cemaker
fill cup
I_PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the icemaker
power cord plug into the socket on the back wall,
making sure the prongs and holes are matched.
Press the plug firmlv into the socket, i,ock the plug
in place by clipping the restraints onto each side of
the plug. Make sm'e the restraints click into place.
[] MOUNT THE ICEMAKER
• I,ifi the icemaker so the fill tube extension fits in
the fill cup opening. Hang the icemaker on the
two screws.
Make sure:
• The power cord is still firmly in the socket.
• The fill tube extension extends into the
fill cup opening at the back of the icemaker.
(Check the rear of the refl'igerator to make sure
the fill tube has not been imshed out of the back
of the refl'igerator).
• The icemaker mounting screws are located in the
ul)permost position of the motmting slots.
THEN SECURELY TIGHTEN THE ICEMAI_]R
MOUNTING SCREWS.
tube
extension
Fillcup
opening
[] INSTALL THE ICE BUCKET
Place the ice bucket m_der the icemaker.
Make sm'e the icemaker power switch is in the
0 (off) position.
Icebucket
I_REMOVE THE COVER
Use a Phillips head screwdriver to relnove the
COlllI)YessoI" COllli)ai'ti/lent access coveI', This
requires removing six screws which attach the
cover to the back of the refl'igerator case.
Be s/li'e to save the scYews as the access covei" iiltlst
be reinstalled later to ensure wmr refligerator will
flmction i)roperly:
14