EasyManuals Logo

GE GTK21GBEBS Instruction Manual

GE GTK21GBEBS
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Installation instructions
REVERSING THE DOOR SWING (CONT.)
[_ REMOVE FREEZER DOOR
Tape the door shut with masking tape.
Remove the binge cover on top of the fleezer doom
Remove the four screws with a 5/16" socket and
ratchet, then lift the binge straight up to flee the
binge pin flom the socket in the top of the door
TopHinge
Remove the tape and tilt the door away flom the
cabinet, i,iR it off the center binge pin.
NOTE: Do not misplace the washer located on the top
side of the center binge pin.
Set the door on a non-scratching smf_tce with
the inside up.
REMOVE REFRIGERATOR DOOR
Tape the door shut with masking tape.
Remove the center binge by removing two binge
screws with a 5/16" socket and ratchet. Elf1 the
binge pin up and out of the door
NOTE: Do not misplace the washer located on the
underside of the center binge pin.
'""--- I
Plastic
Hinc
/
FreshFoodDoor
Remove the rope and flit the door away flom the
cabinet. Lift the door straight up to flee its bottom
socket flom the pin in the bottom binge bracket.
Set the door on a non-scratching smf_ce with the
inside up.
CAUTION: Do not let door drop to the floor.
To do so could damage the door stop.
%
TRANSFER TOP HINGE TO
THE LEFT
Interchange binge and screws at top right with screws
at the top left of cabinet.
Do not tighten screws on hinge side at this time.
[-4]TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, reIIlove it by grasping it
about 6" flom each end and pulling its bottom edge
toward you.
Using a 5/16" socket and ratchet, reiD.ore die 3 screws
flom the bottom binge. Taking care not to misplace
the washer on the bottom binge, move the bottom
binge flom the Hgbt to the left side.
NOTE: ff the washer is not on the binge bracket,
check to see if it is stuck to the bottom of the doo_:
Plastic
i
©_--_ Washer
Bracket
Replace die base grille by inserting die tops of the
metal clips into the ova/vents, maMng sure one of the
plasdc tabs on the back of the grille goes into each of
the ova/vents. Then push the bottom of the gnlle
fbrward until it snaps into place.
22

Other manuals for GE GTK21GBEBS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE GTK21GBEBS and is the answer not in the manual?

GE GTK21GBEBS Specifications

General IconGeneral
BrandGE
ModelGTK21GBEBS
CategoryRefrigerator
LanguageEnglish

Related product manuals