Abouttheautomaticicemaker. CEA,,,ia.ce .com
A newly-installed refrigerator may take 12-24 hours to begin making ice,
Automatic lcemaker (onsomemodels)
There are 2 types of icemakers:
Power
Switch
_x_. !cemaker
G;)
Po;er
Power switch model
FeelerArm n
the ON ieowm
ooskion
Feeler arm model
FeelerArmin
theSTOP
uoJDOSkion
The icemaker will produce approximately
3 to 3½ lbs. of ice in a 24-hour period,
depending on the fleezer compartment
telnperat/]re, rooIll telllperat/lre, ntl[llbei
of door openings and other use conditions.
There are two types of icemakers: power
switch models and fe.eler arIn models.
If tlle refligerator is operated before tile
water connection is made to the icemake_;
set tile power switch to 0 (off) or move the
feeler arI-n to tile STOP(up) position.
¼qlen file refligemtor has been connected
to tile wamr supply, set tlle power switch to
the I (On}posidon or IIlove the feeler arm to
tile ON (down) position. On power swimh
models, die green light will come on.
The icemaker will fill widl water when it
cools to 15°E A new/y-installed refligerator
may rake 12 to 24 hom_ to begin making
ice cubes.
Once file icemaker starts to make ice,
it may rake up to 48 hours to fill file bin,
depending on the mmpemmre settings
and nmnber of door openings.
You will hear a buzzing sound each dine
the icemaker fills with wate,:
Throw away tile first few batches of ice
to allow the water line to clear
Be sure nothing interfe.res with tile sweep
of tile feeler arm.
When the bin fills to the level of tile feeler
arIn, tile icemaker will stop producing ice.
It is normal for several cubes to be joined
together
ff ice is not used flequently; old ice cubes
will become cloudy, taste stole, shrink or
fuse together
On power switch Inodels, tile green power
light will blink if ice cubes get stuck in tlle
icemake_: To correct this, set die power
switch to 0 (0ff)and remove the cubes.
Set tile power switch to / (Oft)to restart die
icemaker After the icemaker has been
turned on again, there will be a del W of
about 45 minutes before tile icemaker
res uIIles operation.
NOTE:Inhomeswithlower@an-averagewater
pressure,youmayheartheicemakercyclemultiple
timeswhenmakingonebatchof lee.
/cemaker Accessory Kit
If your refligerator did not aheady come
equipped with an automatic icemake_;
an icemaker accesso_ T ldt is available at
extra cost.
Check tile back of tile refligerator for tile
specific icemaker kit needed for your model.
This refligerator will accept accessory icemaker IM4A or IM6. Use instruction sheet L
supplied in the kit for assembly inside fleezer compamnent.
To facilitate installation of an icemaker kit, the fbllowing parts are included with your
refligerator:
Part Part Number
Ice Fill Cup WR29X10074
Ice Fill Tube WR17X 12339
Ice Fill Tube Seal WR l7X 12337
NOTE:It is important that you DO NOT discard these parts, as they will be needed if
you plan to install accessory icemaker kit IM4A or IM6.
9
To Next Page
Loading...
Need help?
General
