GE GUD24ESSMWW - Page 38

– 38 –
6. Disconnect the coil wire harness from each
coil.
7. Disconnect the ignitor wire harness and the
WZRZLUHVIURPWKHÀDPHGHWHFWRU
8. Remove the two 1/4-in. hex-head screws
that
DWWDFKWKHJDVYDOYHEUDFNHWWRWKHGU\HUÀRRU
9. Pull the bracket toward the front of the dryer
WRGLVHQJDJHWDEVIURPGU\HUÀRRU
NOTE: Upon assembly, ensure the gas valve
bracket is inserted under the two tabs located in
WKHGU\HUÀRRU
Gas
Valve
Bracket
Disconnect
Disconnect
Tab
Tab
Disconnect
Caution: The ignitor is very fragile. To prevent
breaking the ignitor, care must be taken when
removing or installing the gas valve.
10. Lift the front of the combustion chamber, then
maneuver the gas valve assembly from the
dryer.
11. Remove the coils from the gas valve. (See
Gas Valve Coils in this section of this service
guide.)
12. Turn the bracket over. Remove the three
Phillips-head screws that attach the gas valve
to the gas valve bracket.