GE GUV27ESSMWW - Page 66

– 66 –
Knob Index/
Test number
Test Name Description of test
Lid Switch Pressing Start will start the test.
When the lid is open, the Lid Locked LED will blink.
When the lid is closed, the Spin LED will blink.
Spin Pressing Start will start the test.
Spin test will perform child safety algorithm before it starts to spin.
(Two (2) sprays of water before locking the lid.)
The lid must be closed to start the test. If lid is open the Lid
Locked LED will blink. When started, the mode shift to spin will
occur if required and the lid will be locked. When mode shift is
complete, the unit will begin spinning.
Spin test will have a timeout (4 minutes).
No OOB detection during the spin.
The spin shall stop when the test is exited.
The lid shall unlock once the speed reaches 0 after the test is
exited.
Agitate Pressing Start will start the test.
Agitate test will perform child safety algorithm before it
starts to agitate. The lid must be closed to start the test. If
lid is open, the Lid Locked LED will blink. When started,
the mode shifts to agitate will occur if required. When
mode shift is complete; the washer will begin agitating.
The test will pause if the lid is opened after starting.
The test will resume on lid close if it was running when opened.
The test will stop when the test is exited.
Clear all Fault
Codes
Pressing Start will clear all faults.
Analog Knob Pressing Start will start the test.
(DFKNQRELVUHSUHVHQWHGE\DVSHFL¿FVWDWXV/(':KHQNQRE
SRVLWLRQFKDQJHV/('IRUWKHVSHFL¿FNQRELQGLFDWHVNQRE
position. The far left selection will turn the corresponding LED
RQVROLG:LWKHDFKFOLFNWRWKHULJKWWKH/('IRUWKHVSHFL¿F
knob blinks faster. Clicking back to the left will reduce the blink
frequency until it gets to the far left selection, then the LED will
stay on solid. The left option knob will control the deep rinse LED
("On" LED). The right option knob will control the wash rinse LED
("Wash" LED).
12
13
14
15
16