EasyManuals Logo

GE GXSH40V User Manual

GE GXSH40V
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
20
FEATURE: OTHER DATA DISPLAY
These models have an option to have the
run display indicate different information. The
information displayed on the top half of the
display can be changed to one of the following
by pressing UP
or DOWN
buttons
:
CAPACITY REMAINING
– This is the percentage
of water softening capacity
remaining. Immediately
after a regeneration, 100%
shows. As water is used,
the percentage will decrease until the next
regeneration. During regenerations, the
percentage increments upward.
When present time is displayed, press the
DOWN
button; % Remaining will appear in
the display. The value shown is between 0 and
100 percent. This value is based on current
operating capacity. Pressing the UP
button
will return the screen to the previous display.
AVERAGE DAILY
GALLONS – The figure
displayed is the average
gallons of water used by the
household each day over
the past seven-day period.
Press the DOWN
button again to display
the Average Daily Gallons. Average Daily
Gallons will appear in the display. This value
is updated every night at midnight. Pressing
the UP
button will return the screen to the
previous display.
FLOW RATE, GPM
– When using soft water,
this display shows the flow
rate passing through the
softener (in gallons per
minute). Zero shows if water
is not passing through the softener.
Press the DOWN
button again to display
the flow rate. Gallons/Min will appear in the
display. This value is updated every
1
»2 second.
Pressing the UP
button will return the
screen to the previous display. Pressing the
DOWN
button will return the screen to the
present time display.
RESETTING TO FACTORY DEFAULT
To reset the electronic controller to its factory
default for all settings (time, hardness, etc.):
1. Press the MODE/SET button and hold
until the display changes twice to show the
flashing mode code.
2. Press the UP
button to display a flashing
“SoS”.
3. Press the MODE/SET button and the
electronic controller will restart.
4. Set the present time, hardness, etc, as
described in the Programming the Water
Softener section
Days to Empty
Recharge
Tonight
% Remaining
Days to Empty
Recharge
Tonight
Average Daily
Gallons
Days to Empty
Gallons/Min
Programming the Water Softener

Other manuals for GE GXSH40V

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE GXSH40V and is the answer not in the manual?

GE GXSH40V Specifications

General IconGeneral
BrandGE
ModelGXSH40V
CategoryWater Dispenser
LanguageEnglish

Related product manuals