D
IRECTION 5813707-100, REVISION 2 VENUE™ SERVICE MANUAL
8-4 Chapter 8 - Replacement Procedures
PRELIMINARY
8-2-2-4 Batteries Removal Procedure
1) Move the bottom probe locking lever to its locked position.
2) Raise the system support frame (Kick Stand) to vertical position.
3) Open the battery compartment cover by moving the latch to the right.
4.) Remove the battery.
8-2-2-5 Batteries Installation Procedure
1.) Slide in the battery towards the power connector.
2.) Position the battery properly in its compartment.
3.) Close the battery compartment cover.
4.) Switch On the battery power switch.
5.) Close the battery power switch silicon cover.
Figure 8-72 Opening Battery Compartment Cover
To Next Page
Loading...
