B30 Patient Monitor
11-18
Other adjustable features
NOTE: This section describes the rest of the adjustable features related to ECG
measurement. To adjust the following features, you need a password. If you wish to
adjust the settings of the features, we recommend that you contact the person
responsible for the entire configuration.
ECG printout type
See “Changing printer settings” on page 5-4.
ECG waveform sweep speed
To change the waveform sweep speed, Monitor Setup - Sweep Speeds. Select
Hemodynamics and adjust the value.
Checklist
Check that:
• Electrode gel is moist.
• Electrodes have good skin contact.
• Electrodes are positioned correctly.
• Correct leadwire set is selected.
• The trunk cable is connected properly.
• Leadwire set is properly connected to the trunk cable.
• Correct leadwire type is selected in the ECG Setup menu.
• Pacemaker selection in the ECG Setup menu is Show when a pacemaker is used.
• ECG is selected for screen through Monitor Setup - Screen Setup.
To Next Page
Loading...
