GE IC3645SR3R404P2 - Page 44

DIAGNOSTIC STATUS CODES
SX TRANSISTOR CONTROL Page 44
July 1999
TRACTION
STATUS CODE
DESCRIPTION OF STATUS CAUSE OF STATUS INDICATION
-2XX
Both controls will display status codes
in the -2xx series, i.e. -201 to -299,
indicating a status code mismatch.
This status code will be displayed in both the master
and the slave controls, indicating a fault has occurred
in the slave control only.
MEMORY RECALL
NO
CORRECTIVE ACTIONS TROUBLE-SHOOTING DIAGRAM
Circuits valid
for
Traction
Controller
SYMPTOM
Control will not operate.
POSSIBLE CAUSE
Slave control has experienced a fault,
while the master control attempts to
operate normally.
•= Resolve the corresponding fault
indicated by the last two digits of
the status code which has
occurred in the slave control.
Example:
Both controls exhibit a -201 status code. The fault, as
defined by status code -01 (missing seat switch or
deadman switch signal), has occurred only
with the
slave control. However, neither control will operate,
and both will continue to indicate the -201 status
code, until the slave control fault has been cleared.
TRACTION
STATUS CODE
DESCRIPTION OF STATUS CAUSE OF STATUS INDICATION
-3XX
Both controls will display status codes
in the -3xx series, i.e. -301 to -399,
indicating a status code mismatch.
This status code will be displayed in both the master
and the slave controls, indicating a fault has occurred
in the master control only.
MEMORY RECALL
NO
CORRECTIVE ACTIONS TROUBLE-SHOOTING DIAGRAM
Circuits valid
for
Traction
Controller
SYMPTOM
Control will not operate.
POSSIBLE CAUSE
Master control has experienced a fault,
while the slave control attempts to
operate normally.
•= Resolve the corresponding fault
indicated by the last two digits of
the status code which has
occurred in the master control.
Example:
Both controls exhibit a -301 status code. The fault, as
defined by status code -01 (missing seat switch or
deadman switch signal), has occurred only
with the
master control. However, neither control will operate,
and, both will indicate the -301 status code, until the
master control fault has been cleared.