2-8 PACSystems* RX3i PROFINET Controller Manual – December 2011 GFK-2571A
Removing SFP Devices
Warning
If the surrounding air operating temperature of the PNC module is greater than
40 °C, SFP devices could have operating temperatures over 70 °C (158 °F).
Under these conditions, for your safety, do not use bare hands to remove an
SFP device from the SFP cage. Use protective gloves or a tool (needle-nose
pliers) to avoid handling the hot SFP device directly when removing the SFP
device.
Remove the cable from the SFP device. If the device has a latching mechanism such as a bale
clasp, open it gently. Do not pull on the latching mechanism. Hold the sides of the SFP device and
pull it out of the PROFINET Controller port.
To Next Page
Loading...
