GE Innova IGS 520 - 3.3.3.2 2360538 - Tilting table Add-On Kit

3.3.3.2 2360538 – Tilting table Add–On Kit
Table 2-13:
Item Name Part # Description Quan. Notes
Omega ta‐
ble/ Tilting
table com‐
mon Plate
2361993
Plate to be anchored under the ta‐
ble
1 pc
Hex Screws 5120708 Screw M16x40x40 Inox A4-70
Pass
10 pc 4 only are used for Omega
Washer,
Flat
99125091 Washer Plain - Large 17 mm/40
mm
10 pc
Floor An‐
chor
46-302265P1 5/8 diameter 6” floor anchor bolts 6 pc
Dowel 2290937-2 Wood Dowel; 16 mm diameter 6 pc
Bolt, Hex 2296892 Through bolt M20-500-400 6 pc
Washer,
Flat
99142204 Washer plain 21 mm/40 mm for
Through Bolts; one for each bolt
6 pc
Plate 2290941 Special Steel Spacer Plate; 4 in. x
4 in. (102 mm x 102 mm); one for
each bolt
6 pc
Nut, Hex 99141607 Hex Nut M20 STL galvanized, two
for each bolt
12 pc
Dowel 2290937 Wood Dowel; 24 mm diameter 6 pc
Cap 5130979 Plastic Cap 10 pc
M16 Plug 5130982 Plastic Plug 6 pc see note *
NOTE: * M16 plug is needed only when Omega V table is replaced by Tilting table.
Therefore, these plugs have to be kept (bag let inside the table base) until Tilting table
is installed (no need to fit them with Omega table).
Innova
TM
IGS 520, Innova
TM
IGS 530, Innova
TM
IGS 540 Pre-Installation Manual
Direction 5499972-1-1EN, Revision 2
152 3 Room Structural Requirements