3.4 Route Survey
3.4.1 Step One — Sketch
Start preparing Route Survey by sketching a floor plan of the hospital or clinic which will receive
the equipment. Include all areas on the delivery route from outside the building to destination.
See Illustration 1-12.
Reference Numbers: Numbers in circles refer to Route Survey data. The Route Survey is a form
on which site data are listed (see Section 3.4.2).
Illustration 1-12:
3.4.2 Step Two — Survey
Data concerning the intended delivery route are recorded on the Route Survey in the following
pages. Record all loading capacities, corridor widths, door openings, turning radii, flooring
materials, elevator sizes, obstructions and so on.
3.4.3 Step Three — Check
Verify equipment can be transported via the route specified in Section 3.4.1. Compare Route
Survey compiled in Section 3.4.2 to equipment specifications in this and other applicable pre–
installation directions.
Innova
TM
IGS 520, Innova
TM
IGS 530, Innova
TM
IGS 540 Pre-Installation Manual
Direction 5499972-1-1EN, Revision 2
40 3 Delivery Requirements
To Next Page
Loading...