3.4 Ceiling Requirements
Aluminum rails support the In-Room Monitor bridge used in Innova system X-Ray rooms.
Reference:
For additional details on ceiling requirements for stationary rails, refer to: - Direction 46-019639,
Advantx (VHLA) XT Stationary Rails Installation and Adjustment
.
When evaluating ceiling you must take into account the following mounting information:
3.4.1 Rail Mounting
Attach stationary rails to structural steel with through-bolts in concrete ceilings. Do not use
screw anchors in direct tension.
Mount stationary rails directly to the ceiling slab or to flush–mounted unistrut or halfen structure.
In higher rooms with false ceiling, mount stationary rails to rigid vertical members hung from
ceiling slab.
Securing a supplementary channel to the bottom of the vertical members and mounting the
stationary rails to this channel can greatly reduce the number of vertical members.
The stationary rail support structure must be leveled before installation can begin. Do not
assume that any support structure is level within specified tolerances, particularly after removing
suspensions from an existing room.
3.4.2 Bolt Specifications (Mavig suspensions)
•
The maximum load per bolt will not exceed 1557 N.
•
Each bolt must not “pull out” or otherwise fail under a vertically downward
dead
load of 6227
N.
3.4.3 Select Rails (Mavig suspensions)
All XT Stationary rails are with a select length process. Detail of available length is illustrated in
Chapter 1, European Process Order Select.
Innova
TM
IGS 520, Innova
TM
IGS 530, Innova
TM
IGS 540 Pre-Installation Manual
Direction 5499972-1-1EN, Revision 2
160 3 Room Structural Requirements
To Next Page
Loading...