GE Innova IGS 540 - 2.3 IVUS Wiring; 2.3.1 For IVUS rev 2 wiring; 2.3.2 For S5 I GE rev 2+ wiring

2.3 IVUS Wiring
2.3.1 For IVUS rev 2 wiring
The connection cables between the IVUS Control Room and Procedures Room components run
in a dedicated under floor conduit (see Cable Channelling).
A GND wire between the C1 cabinet and the IVUS Rev 2 CPU runs in the underfloor conduit
prepared for the Control Booth cables between Equipment Room and Control Room.
Illustration 5-15: IVUS rev 2 wiring
2.3.2 For S5I GE rev 2+ wiring
The connection cables between the S5I GE Control Room and Procedures Room components
run in a dedicated under floor conduit (see Cable Channeling).
Innova
TM
IGS 520, Innova
TM
IGS 530, Innova
TM
IGS 540 Pre-Installation Manual
Direction 5499972-1-1EN, Revision 2
222 2 System Cable Information