GE Innova IGS 540 - 2.4.4.2 Run Interconnection cables through the Conduit; 2.4.4.2.1 For IVUS Rev 2 option

2.4.4.2 Run Interconnection cables through the Conduit
2.4.4.2.1 For IVUS Rev 2 option
Use the IVUS Rev 2 PIM (#806365002) as reference to the procedures below.
•
Unpack , and check the completeness of the Preinstallation kit :
○
1 pcs - Custom PIM cable 30 m (98 ft, 5 in) - Volcano ID :806452001
○
1 pcs - CAT5 cable 30 m (98 ft, 5 in) - Volcano ID :807055001
○
1 pcs - Custom Twin axial cable - Volcano ID :806380001
○
1 pcs - Ground Cable, 30 m (98 ft, 5 in) s5i – Volcano ID :806889001
○
1 pcs - IVUS Rev 2 Preinstallation Manual - Volcano ID :806365002
•
Install 806889001 Ground Cable through the Control Booth conduit (see note)
•
Install the cables through the IVUS conduit from the Control Room end :
○
806452001 PIM cable, round shaped connector end to the Procedures Room
○
807055001 - Ethernet cable (1 pcs)
•
Install the optional cables through the IVUS conduit from the Control Room end :
○
806380001 - ECG cable in case, if NON Mac-Lab ECG will be installed
○
808631002 – FFR cable option - 15m
○
808632002 – FFR cable option - 27m
NOTE:
For the ground cable, see the IVUS Rev 2 service manual for special
instructions concerning cable running and cutting .
NOTE:
If the installation has the MaC-Lab ECG in the configuration, the ECG cable
shall not be run through the conduit, it will be used in the Control Room to
connect Mac-Lab and IVUS PCs.
NOTE:
You should consider running the ECG cable through the conduit in case, the
customer requires interconnecting to a NON Mac-Lab ECG at the table base.
In this case you shall hide the unconnected cable in the conduit for future
expansion options.
NOTE: Same applies to the 2nd Ethernet cable, if a later extension of the IVUS
remote controls expected.
•
Ensure sufficient cable length on the Procedures Room end of the cables according to the
table below
Cable Free length from the conduit exit
IVUS PIM cable * 2.4 m (8 ’)
FFR cables for Pimette ** 0m (0’)
Innova
TM
IGS 520, Innova
TM
IGS 530, Innova
TM
IGS 540 Pre-Installation Manual
Direction 5499972-1-1EN, Revision 2
228 2 System Cable Information