3.2 Tools and Test Equipment
Refer to Table 1-2. To obtain a list of tools and test equipment for components not specified in
Table 1-2, refer to the appropriate component Pre-Installation Manual listed in Chapter 2, Basic
Innova System Compatibility.
Table 1-2:
PRODUCT OR COM‐
PONENT
TOOL OR TEST EQUIP‐
MENT
USED FOR SOURCE RECEIVED (DATE)
Innova LC Positioner Service Engineer's Tool
Case
General Use
Level, Protractor Type Positioner Checks
Plumb Line included in
46-216640G1
Positioner Checks
Torque Wrench 2 to 20
daN.m (15 ft. lbs. to 150
ft. lbs.)
Positioner Checks
1/2 inch Ratchet Wrench
(2)
Raise and Lower Posi‐
tioner shipping dolly
Wrench, Spanner
(46-176584P1)
High Voltage Cable In‐
stallation
Laptop Computer (MS-
DOS Windows)
Positioner Configura-tion
and Calibration
Status Display Same as for Innova LC (Service Engineer's Tool Case)
Omega/Tilting table Same as for Innova LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as
required
Installation dolly (PN
5265134)
Replacing Omega with
Tilting table
C2 Cabinet Same as for Innova LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as
required
X-Ray Head Same as for Innova LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as
required
C1 Cabinet Same as for Innova LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as
required
Same as for Innova LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as
required
Ethernet adaptation kit
for laptop 2128794
General use (to be or‐
dered before delivery of
system)
Innova
TM
IGS 520, Innova
TM
IGS 530, Innova
TM
IGS 540 Pre-Installation Manual
Direction 5499972-1-1EN, Revision 2
Chapter 1 General Requirements 37
To Next Page
Loading...