NOTE
(1): The target temperature (best recommended) is 18°C (64°F).
The target humidity (best recommended) is 50% RH.
NOTE
(2a): In use temperature limits specify the range where the system shall work. Operating
outside these limits could occur severe performance and reliability issues.
(2b): Recommended temperature limits specify the range where it is recommended to
adjust air conditioning control in order to warranty current operations inside the in use
range.
Relative Humidity and Temperature: Refer to Table 4-1 In use - Humidity and
Temperature on page 129. To obtain relative humidity and temperature requirements for
components not specified in Table 4-1 In use - Humidity and Temperature on page 129,
refer to the appropriate component Pre–Installation Manual listed in 2.1.5 System
Compatibility on page 71.
NOTICE
In some cases condensation occurs and water drops from outlets and pipes of
the air conditioner in the technical room.
Therefore, it is critical to install the cabinets where there is no risk of flood from
the air conditioner.
4.2 Altitude and Atmospheric Pressure
Refer to Table 4-1 Altitude and Atmospheric Pressure on page 130. To obtain altitude and atmospheric
pressure requirements for components not specified in Table 4-1 Altitude and Atmospheric Pressure on
page 130, refer to the appropriate component Pre–Installation Manual listed in 2.1.5 System
Compatibility on page 71.
For storage and transport, individual products or components are classed separately, refer to 1.4 Product
Storage and Handling Requirements on page 25.
Table 4-1 Altitude and Atmospheric Pressure
INSTALLATION ROOM OF PRODUCT
OR COMPONENT
ALTITUDE (meters) ATMOSPHERIC PRESSURE (kPa)
IN-USE IN-USE
MIN MAX MIN MAX
Examination room 0 3000 70 106
Technical room 0 3000 70 106
Control room 0 3000 70 106
Environmental Requirements
130
Innova
TM
IGS 6
5750182-1EN 3
To Next Page
Loading...